hardy water lily
Nymphaea 'Marliacea Chromatella'
Cycle:
Herbaceous Perennial
Watering:
Frequent
Propagation:
Division,Seed Propagation,Cutting,Layering Propagation
Hardiness Zone:
4 - 10
Flowers:
Yellow Flowers
Sun:
Full sun,part shade
Leaf:
Yes
Leaf Color:
green,yellow
Growth Rate:
Low
Maintenance:
Low
Drought Tolerant:
Yes
Salt Tolerant:
Yes
Care Level:
Moderate
watering
Hardy water lilies (Nymphaea 'Marliacea Chromatella') thrive in moist soil and can be grown in either a pond or tub garden. The optimal water temperature for this plant species is between 65 and 70 degrees Fahrenheit. They should be planted in a container filled with soil that covers the roots at least 11 inches deep. Place the pot in a 6-inch layer of water and keep the water level consistent. If planting the lily in your pond, make sure the water is at least 6 inches deep. Hardy water lilies prefer to grow in direct sunlight, but will thrive in partial shade as well. When watering, keep the soil slightly damp at all times. Do not let the plant dry out completely. Water every 5 to 7 days during the spring and summer. During the winter months, water less often, allowing the soil to dry out a bit in between watering.
sunlight
The hardy water lily (Nymphaea 'Marliacea Chromatella') needs full sun to thrive and bloom. This means that it should receive direct sunlight for at least 6 hours a day. It's best to give the plant access to the sun starting in the morning and continuing throughout the day until early afternoon. If the plant doesn't get direct sunlight, it may not bloom or produce healthy foliage. However, it is important to note that this plant is considered hardy, so it can handle partial sunlight and shade. Therefore, if you cannot provide it with full sun for the recommended 6 hours a day, it will still be able to survive, though it may not reach its full potential.
pruning
Pruning for the Hardy Water Lily (Nymphaea 'Marliacea Chromatella'), should be done during the early springtime (late February through early April). Pruning should be done to ensure the plant stays in a healthy state. Dead, diseased, or dried out parts of the plant should be removed, as should any dead foliage. Stems should be pruned at least 6 inches below the water surface to allow for the healthy growth of new leaves and flowers. Any damaged foliage should not be pruned, as this can remove unnecessary nutrients and energy from the plant. When pruning, try to avoid cutting too much, as over-pruning can lead to a decrease in blooming and increase the chances of disease.
