Tutsan typically starts flowering in June.
tutsan
Hypericum androsaemum 'Golden Tutsan'
Cycle:
Perennial
Watering:
Average
Propagation:
Cutting,Layering Propagation,Division,Grafting Propagation,Stem Propagation,Root Cutting
Hardiness Zone:
6 - 9
Flowers:
Yellow Flowers
Sun:
Full sun,part shade
Leaf:
Yes
Leaf Color:
gold,green,yellow
Growth Rate:
Low
Maintenance:
Low
Drought Tolerant:
Yes
Salt Tolerant:
Yes
Thorny:
Yes
Care Level:
Medium
watering
Tutsan (Hypericum androsaemum 'Golden Tutsan') will benefit from deep watering about once per week during the growing season, typically from spring through fall. Water slowly and deeply to thoroughly soak the soil until water begins to come out of the bottom of the pot. When the top surface of the soil begins to dry out, it is time to water again. Allow the plant to dry out slightly before watering during winter, when it is not actively growing. When watering, always check the drainage hole in the bottom of the pot to ensure the excess water is draining away properly. The plant should not sit in standing water.
sunlight
Tutsan, or Hypericum androsaemum 'Golden Tutsan', grows best in full sun or partial shade and requires 6-8 hours of sunlight per day. In areas with mild winters, they will do well until temperatures dip below -1°C. In more extreme climates, Tutsan may need to be moved to a sheltered, sunny spot during winter to ensure the plant remains healthy. In these climates, full sun for at least 4 hours a day is recommended.
pruning
Pruning Golden Tutsan (Hypericum androsaemum) should be done twice a year to ensure the plant remains healthy and vigorous. Prune in late winter/early spring (February/March) before bud break - this will create a rounded form and help to eliminate dead, diseased or damaged wood. Prune again in summer (July/August) after flowering is finished. This will ensure a tight growth habit and prompt new growth. Simply remove any dead, damaged, or diseased stems and cut away any stems that are growing out of bounds or look too straggly. Remember to make clean, angled cuts close to the parent stem.